Can you just upload a photo of your RaspberryPi receiver with other components such as WiFi dongle and HDStar tuner.
you can’t
I think s/he meant using USB card reader.
he 
and thanks for your fast reply
maybee using 16GB sd solve the problem?
I need a photo of your HARDWARE. Can you upload? 
I’m using a class 4 4GB card.
whats the photo of my hardware tell to you?
maybee ORxPi2 not recognize my linksys WUSB100 wifi dongle?
It’s possible. So, I’ve reread your posts. How do you tell if orxpi2 is booting or not?
Then try this method.
- Boot the Pi with SD card. Wait for few minutes.
- Connect the Pi with router using Ethernet cable.
- Log in to your router and find the IP address assigned to your Pi.
- Try to access the Librarian (Outernet user interface) with IP xxx.xxx.x.x using your web browser.
you will get a configuration page and after configured you will get a page like this, but without folders.
I had a CRDA error that was beating me completely up the other day. I could not figure it out for the life of me and the problem ate up about 3 hours of my life. Until I saw that I was trying to boot a Pi2-image on a B+. Once I replaced the B+ with a Pi2, the CRDA error magically disappeared.
You actually managed to boot a Pi2 image on B+ and get that far?
1 Like
Yeah, if I recall correctly, wifi even spun up.
i try this image(and all ORxPi2 images)
https://archive.outernet.is/images/ORxPi2-latest.img.zip
CRDA error still remain
Are you sure you have a Raspberry Pi 2, not the Raspberry Pi 1 B+ ?
1 Like
Yeah, I’m very doubtful a Pi2 image would even boot on Pi1. It’s built for ARMv7 and Pi1 is ARMv6.
yeah different architecture…
Yes, you have a raspberry pi 2 board. Is your orxpi working now?
are you kidding with me?